How to Repair Sage 50 File System Error 3110

Sage 50 is a well-known accounting software in the present day. It is user-friendly and easy to use by anyone. The user doesn’t need to be trained in technical terms. It is easy to use by non-technical users. When a client and workstation are waiting for a response from the host computer and the server, it is time out over the network “file system error 3110” is caused. Read the article to know the causes and solutions to fix the Sage 50 error 3110.

The exact error message is shown…

Sage 50 Error: “File system 3110 in [filename]”

Causes of Sage 50 Error 3110

The cause of the Sage 50 fatal file system error may be the loss of network connection between the server and workstations.

• Due to a poor network connection between the server and workstation while using Sage.
• When a client and workstation are waiting for a response from the host computer and the server, it is time out over the network.
• VPNs being used
• Server being rebooted
• Network cable damage
• A bad NIC sending junk data
• Network Interface Cards (NIC) is going into hibernation mode
• Wireless networks
• Other network software interfering
• The network router is unplugged

How to Resolve Sage 50 Error 3110

To solve the Sage 50 error 3110:File restarts the pervasive, run repair on Sage over the Server. After running the Repair Restart the Pervasive.

Solution 1: Restart Pervasive Service

• Access the ‘Run‘ window by using Windows+R keys and type services.msc and press OK
• From the list of services select and right-click Pervasive PSQL V11 Workgroup engine and click on Stop
• Once the service is stopped, again right-click on the service, and from the given options select Start

Solution 2: Repairing the Damage

• The file needs to be renamed and click on run to repair the error on the server.
• Here you need to follow each step to fix the error. Please follow the processors one by one.
• Here you will see the option, how to locate company directions’, you need to click on it to fix the error.
• Before performing these steps, the user needs to restore a good backup. After this, you can delete or index the company file. On the other hand, if the user cannot open the company data or file in their company data folder. At this time also, they need to restore a backup file on their system.

Solution 3: Set Windows to Prefer IPV4 Address Over IPV6

Steps to change network protocol preference from IPv6 to IPv4:

• Use an admin account to log into Windows.
• Press Windows + R to open the run command.
• Input Regedit in the text field, and hit enter.
• From the left pane, navigate to HKLM\SYSTEM\CurrentControlSet\Services\Tcpip6\Parameters.
• Choose the New Key option to create a new registry key.
• Fill in the following information required for creating a new key option:
  • Key: DisabledComponents
  • Type: REG_DWORD
  • Value: 0x20